Skip to main content

Sequences: Why a Contact Stopped, How to Restart or Re-Enter, Who Can Share or Clone

Why a recipient stopped in a Sequence, what you can do for each status, how to restart or re-enter someone, and how cloning and ownership work.

Written by Amogh Balikai

Who this is for: Recruiters who see a recipient marked Responded, Stopped, Unsubscribed, Bounced, or Completed and want to know why it happened, whether they can restart outreach, and how cloning and ownership work.

Why a recipient stopped

Open the Recipients tab in the Sequence and read the recipient's status. Each status has one cause.

  • Responded or Meeting Booked: The Stop sequence if response is received setting is on (the default). A reply through any channel, or a meeting booked through Recruiterflow, ended the Sequence for that person. Task completions do not trigger this.

  • Stopped: A teammate used Actions → Stop Sequence on the recipient. This is permanent.

  • Unsubscribed: The recipient unsubscribed or was added to the global suppression list. No Sequence can send them outreach.

  • Bounced: Every email address on the profile hard-bounced. Recruiterflow tries other addresses on the profile before it reaches this status.

  • Error: A step failed, for example because an integration disconnected, an email address is missing, or a phone number is invalid. Click the status to open the Errors tab for the specific cause.

  • Paused: You paused the recipient, or the whole Sequence is paused.

  • Completed: The recipient finished every step.

How to restart or re-enter a recipient

What you can do depends on the status.

  • Paused: Click Options → Resume Recipient. The delay clock continues from where it stopped. It does not start over.

  • Error: Fix the cause, such as reconnecting an integration or adding the missing email or phone number. You can also skip the errored step or edit the content for that recipient.

  • Responded or Meeting Booked: The Sequence has ended for that person. If you want follow-ups to continue after replies, turn off Stop on Response in the Sequence's Settings tab. The change affects future replies only and does not restart recipients who already replied.

  • Stopped: You cannot resume a stopped recipient, and you cannot add them back to the same Sequence. Add them to a different Sequence, or clone the Sequence and add them to the clone.

  • Bounced: Add a working email address to the profile, delete the recipient from the Sequence, then add them again.

  • Unsubscribed: You cannot restart outreach to someone who unsubscribed or is on the suppression list.

  • Completed: The only available action is delete.

If Recruiterflow says the recipient is already in another Sequence: By default, a person can be in only one active or paused Sequence at a time. The prompt offers Remove & Add Here or Cancel. An Admin can allow the same person in several Sequences under Automation Settings → Sequence Configurations.

Cloning a Sequence

Cloning gives you a new Sequence in Draft state that you can edit and launch without rebuilding.

  1. Go to the Sequences page.

  2. Click the Options icon on the Sequence.

  3. Select Clone Sequence and confirm.

The clone keeps the steps, step content, delays, sender list, schedule, attached job, stopping rules, and branches. It does not copy recipients, historical reporting, or the scheduled launch time. The clone keeps the original name, so rename it before launching.

Who owns the clone: The person who runs the clone action owns the new Sequence, even when they clone a teammate's Sequence.

Did this answer your question?